Cumulus.ini (preserving history): Difference between revisions

Cumulus.ini (preserving history) (view source)

Revision as of 19:10, 10 January 2021

136 bytes added , 19:10, 10 January 2021

m

→‎Spike Removal

Sfws

5,838

edits

@@ Line 1,163: / Line 1,163: @@
 ==== Spike Removal ====
-* {{Version badge 1}} 7 of the 10 spike removal parameters listed below are adjusted in the frame at the bottom of the ''Calibration'' screen, off '''Configuration''' menu, they have a prefix of EW because they were introduced for dealing with problems seen in the Fine Offset family; the corrections are only applied when Cumulus 1 is reading directly from the station at a very frequent interval, spike removal does not apply when Cumulus is re-started and is transferring observations from the station logger to the Cumulus monthly log.
+* {{Version badge 1}} This section was written when only Cumulus 1 was available, so the parameters are listed with defaults applicable up to Cumulus 1.9.4.
+*7 of the 10 spike removal parameters listed below are adjusted in the frame at the bottom of the ''Calibration'' screen, off '''Configuration''' menu, they have a prefix of EW because they were introduced for dealing with problems seen in the Fine Offset family; the corrections are only applied when Cumulus 1 is reading directly from the station at a very frequent interval, spike removal does not apply when Cumulus is re-started and is transferring observations from the station logger to the Cumulus monthly log.
 *The other 3 spike removal parameters have to be entered directly in cumulus.ini, none of these ones can be set on the 'calibration' screen.
 *As Cumulus does not check station type before applying any of these settings, ensure for Davis stations (these do not have spike problems) the spike removal filters are set to the defaults shown below.