5,838
edits
Cumulus.ini (preserving history): Difference between revisions
Cumulus.ini (preserving history) (view source)
Revision as of 14:17, 13 April 2020
, 14:17, 13 April 2020→Introduced for problems with Fine Offset family:: paste
m (→Section: Station: cut) |
|||
| Line 891: | Line 891: | ||
Option to turn off reporting of 'lost sensor contact' for Fine Offset stations. (added Cumulus 1.9.4 b.1070) | Option to turn off reporting of 'lost sensor contact' for Fine Offset stations. (added Cumulus 1.9.4 b.1070) | ||
|- | |||
|UseZeroBearing=0 | |||
|Selected on same screen as other parameters. Intended for weather stations that do not supply a wind bearing, so Cumulus has to calculate it from reported compass direction. | |||
*0 = Disabled, Cumulus displays the current bearing read from the station (i.e. the last direction the wind was blowing from before it became calm). Note that the average wind bearing will always display zero bearing if there has been no wind for the last N minutes (where N is defined by previous parameter if present but defaults to 10), as the average bearing takes wind speed into account. | |||
*1 = Enabled, Cumulus display a bearing of zero (and '---' for the compass point) when the wind is calm (note when not calm, bearing is 360 for true North) | |||
|- | |- | ||
|EWdisablecheckinit=0 | |EWdisablecheckinit=0 | ||
| Line 896: | Line 901: | ||
*0 = Disabled, default, it checks the first two bytes of the Fine Offset station's memory. | *0 = Disabled, default, it checks the first two bytes of the Fine Offset station's memory. | ||
*1 = Ignores part of memory (see [[FAQ#When_I_start_Cumulus.2C_I_get_the_error_message_.22The_station_is_not_initialised.22]]). | *1 = Ignores part of memory (see [[FAQ#When_I_start_Cumulus.2C_I_get_the_error_message_.22The_station_is_not_initialised.22]]). | ||
|- | |- | ||