5,838
edits
Cumulus.ini (preserving history): Difference between revisions
Cumulus.ini (preserving history) (view source)
Revision as of 22:28, 4 September 2013
, 22:28, 4 September 2013→Introduced for problems with Fine Offset family, but may be more widely applicable:: added EWdisablecheckinit=
m (→Introduced for problems with Fine Offset family, but may be more widely applicable:: Added 'Only relevant if all conditions met') |
m (→Introduced for problems with Fine Offset family, but may be more widely applicable:: added EWdisablecheckinit=) |
||
| Line 381: | Line 381: | ||
*0 = Disabled, default i.e. deselected on the Station Configuration Screen | *0 = Disabled, default i.e. deselected on the Station Configuration Screen | ||
*1 = Enabled as selected on the Station Configuration Screen | *1 = Enabled as selected on the Station Configuration Screen | ||
|- | |||
|EWdisablecheckinit=0 | |||
|Add this line to cumulus.ini [Station] section if application gets stuck when Cumulus starts up connected to a Fine Offset (clone) station (added Cumulus version 1.9.3, build 1034). | |||
*0 = Disabled, default, it checks the first two bytes of the Fine Offset station's memory. | |||
*1 = Ignores part of memory (see [[FAQ#When_I_start_Cumulus.2C_I_get_the_error_message_.22The_station_is_not_initialised.22]]) | |||
|- | |||
|EWduplicatecheck=0 | |||
|Add this line to cumulus.ini [Station] section if application gets stuck in the download stage. | |||
|- | |||
|SyncFOReads=1 | |||
|Specifies the Fine Offset synchronisation mode of operation. | |||
*0 = default | |||
*1 = Re-synchronizes each day | |||
|- | |||
|ReportLostSensorContact=0 | |||
|Option to turn off reporting of 'lost sensor contact' for Fine Offset stations. (added Cumulus 1.9.4 b1070) | |||
*0 = reporting off | |||
*1 = reporting on (default) | |||
|- | |- | ||
|EWpressureoffset=x.y | |EWpressureoffset=x.y | ||
| Line 411: | Line 429: | ||
|EWhumiditydiff=999.0 | |EWhumiditydiff=999.0 | ||
|A humidity change 'spike removal' filter, ''changes in read value''from any station greater than the value specified here (set in calibration screen of configuration menu) will be ignored by Cumulus | |A humidity change 'spike removal' filter, ''changes in read value''from any station greater than the value specified here (set in calibration screen of configuration menu) will be ignored by Cumulus | ||
|} | |} | ||