1,122
edits
Cumulus.ini (preserving history): Difference between revisions
→Section: Station: Added most missing descriptions
(→Section: Station: Added some missing params, no descriptions) |
(→Section: Station: Added most missing descriptions) |
||
| Line 308: | Line 308: | ||
|When set to 1 stops new Longest Wet/Dry Period records being 'flashed' | |When set to 1 stops new Longest Wet/Dry Period records being 'flashed' | ||
|- | |- | ||
|UseSpeedForAvgCalc | |UseSpeedForAvgCalc=0 | ||
| | |When enabled (=1) Cumulus will use the longer-term 'speed' values in the average speed calculation. The 'Use 10-min average wind speed' option must be selected for this option to have any effect. | ||
|- | |- | ||
|HourlyForecast | |HourlyForecast=0 | ||
| | |If Cumulus is set to generate a forecast, this setting (=1) causes the forecast to be updated only once an hour (on the hour). | ||
|- | |- | ||
|RoundWindSpeed | |RoundWindSpeed=0 | ||
| | |When set to 1, this setting causes wind speeds rounded to the nearest integer. | ||
|- | |- | ||
|VP2PeriodicDisconnectInterval | |VP2PeriodicDisconnectInterval=0 | ||
| | |Causes Cumulus to disconnect for the specified number of seconds, once a minute, on the minute (or as close as possible) to allow the Weatherlink IP to connect to the Davis Weatherlink site. Set it to zero to disable, if you are not using the Weatherlink site. | ||
|- | |- | ||
|EWminpressureMB | |EWminpressureMB=900 | ||
| | |Cumulus will ignore all pressure readings from the station that are less than this value (units are always hPa/millbars) | ||
|- | |- | ||
|EWmaxpressureMB | |EWmaxpressureMB=1200 | ||
| | |Cumulus will ignore all pressure readings from the station that are greater than this value (units are always hPa/millbars) | ||
|- | |- | ||
|ErrorLogSpikeRemoval | |ErrorLogSpikeRemoval=0 | ||
| | |??? | ||
|- | |- | ||
|LogExtraSensors | |LogExtraSensors=0 | ||
| | |Set this to 1 if you have additional sensors (e.g. a Davis Leaf Wetness probe) to make Cumulus read, display, and log the readings from the sensors. You don't need to select this for Solar/UV sensors. | ||
|} | |} | ||