Cumulus.ini (preserving history): Difference between revisions

Cumulus.ini (preserving history) (view source)

Revision as of 14:15, 13 April 2020

1,075 bytes removed , 13 April 2020

m

→‎Section: Station: cut

Sfws

5,838

edits

Revision as of 08:45, 14 April 2020 (view source) Sfws (talk \| contribs) m (→‎Section: Offsets) ← Older edit		Revision as of 14:15, 13 April 2020 (view source) Sfws (talk \| contribs) m (→‎Section: Station: cut) Newer edit →
(3 intermediate revisions by the same user not shown)
Option to turn off reporting of 'lost sensor contact' for Fine Offset stations. (added Cumulus 1.9.4 b.1070) \|-▼ ~~\|UseZeroBearing=0~~ ~~\|Selected on same screen as other parameters. Intended for weather stations that do not supply a wind bearing, so Cumulus has to calculate it from reported compass direction.~~ 0 = Disabled, Cumulus displays the current bearing read from the station (i.e. the last direction the wind was blowing from before it became calm). Note that the average wind bearing will always display zero bearing if there has been no wind for the last N minutes (where N is defined by previous parameter if present but defaults to 10), as the average bearing takes wind speed into account. 1 = Enabled, Cumulus display a bearing of zero (and '---' for the compass point) when the wind is calm (note when not calm, bearing is 360 for true North) \|- \|EWdisablecheckinit=0 0 = Disabled, default, it checks the first two bytes of the Fine Offset station's memory. 1 = Ignores part of memory (see [[FAQ#When_I_start_Cumulus.2C_I_get_the_error_message_.22The_station_is_not_initialised.22]]). \|- (Note this attribute appears in [[#Davis_family_specific\|Davis family]], [[#Oregon_Scientific_specific:\|Oregon Scientific specific]] and [[#Introduced_for_problems_with_Fine_Offset_family:\|Fine Offset family]] tables above with different usage explanations). \|} === Section: Offsets === \|style="background:lightgray;"\|[Offsets] \|style="background:lightgray;"\|Section Name - the following 'attribute=value' parameters are the adjustment factors for your specific sensors \|- ~~\|colspan="3" style="background:lightblue;"\| Both Cumulus flavours~~ \|- \|PressOffset=Offset_Value \|UVMult=1 \|Multiplier by which measured UV to be corrected (default=1). \|- ~~\|colspan="3" style="background:lightblue;"\| Cumulus MX only~~ \|- ~~\|PressMult = 1.0~~ ~~\|Cumulus MX only from version 3.2: First order multiplier by which measured Pressure (in above formula) is to be corrected (default=1).~~ \|- \| ~~\|Solar multiplier~~ \|- \| ~~\| Solar offset~~ \|} \|- \|colspan="3" style="background:lightblue;"\| Cumulus 1 only ▲\|- \|- \|Background=12632256