1,635
edits
Raspberry Pi Image: Difference between revisions
m
→Verify your SSH Connection
| Line 77: | Line 77: | ||
** ''The build has set a default which is for '''en_UK UTF-8''' locale and '''GMT''' timezone''. | ** ''The build has set a default which is for '''en_UK UTF-8''' locale and '''GMT''' timezone''. | ||
** Use '''sudo raspi-config''' 5. Localization Options, L1 Locale (select en_US ISO-8851-1 for USA if needed) and L2 Timezone (select the appropriate timezone), then '''sudo reboot''' if needed to engage the new settings. | ** Use '''sudo raspi-config''' 5. Localization Options, L1 Locale (select en_US ISO-8851-1 for USA if needed) and L2 Timezone (select the appropriate timezone), then '''sudo reboot''' if needed to engage the new settings. | ||
** NOTE: if you are using ''bullseye'', verify all locale settings are the same (run: locale). If not then edit /etc/default/locale and add (or change) LC_ALL=<locale wanted>. save, exit and reboot again. | ** NOTE: if you are using ''bullseye'' (or up), verify all locale settings are the same (run: locale). If not then edit /etc/default/locale and add (or change) LC_ALL=<locale wanted>. save, exit and reboot again. | ||
* Check the status of the Cumulus MX service with the command '''sudo systemctl status cumulusmx'''<br /> | * Check the status of the Cumulus MX service with the command '''sudo systemctl status cumulusmx'''<br /> | ||
: You will get some information back, the important bit to note is the line starting '''Active:''', it should say '''active (running)''' | : You will get some information back, the important bit to note is the line starting '''Active:''', it should say '''active (running)''' | ||