5,838
edits
Rain measurement: Difference between revisions
m
→Optical Rain Gauges: Amended pin numbers to 9 pin connector
m (→Optical Rain Gauges: updating cross ref) |
m (→Optical Rain Gauges: Amended pin numbers to 9 pin connector) |
||
| Line 56: | Line 56: | ||
== Optical Rain Gauges == | == Optical Rain Gauges == | ||
One design has a row of collection funnels. In an enclosed space below each funnel is a [http://en.wikipedia.org/wiki/Laser_diode laser diode] and a [http://en.wikipedia.org/wiki/Photodiode phototransistor detector]. When enough water has been collected to form a single drop it drips from the bottom of the funnel, falling into the laser beam's path. The detector is set at right angles to the path of the laser beam so that light scattered by the drop of water breaking the laser beam is detected as a sudden flash of light. The flashes from these photodetectors are then read and transmitted or recorded. | #One design has a row of collection funnels. In an enclosed space below each funnel is a [http://en.wikipedia.org/wiki/Laser_diode laser diode] and a [http://en.wikipedia.org/wiki/Photodiode phototransistor detector]. When enough water has been collected to form a single drop it drips from the bottom of the funnel, falling into the laser beam's path. The detector is set at right angles to the path of the laser beam so that light scattered by the drop of water breaking the laser beam is detected as a sudden flash of light. The flashes from these photodetectors are then read and transmitted or recorded. | ||
#The [http://www.rainsensors.com/| Hydreon Optical Rain Sensor] - Model RG-11 - uses an infrared sensor to detect rainfall with high precision. Some car windscreens have a similar sensor to automatically start wipers. Cumulus supports the RG11, via parameters in [[Cumulus.ini#Hydreon_specific:]] that are set using a RG11 screen within the configuration menu. Use a USB to RS232 (serial) adapter on computers which don't have a COM port. See Cumulus ''help'' for more information. The rain sensor's 'normally open' relay contacts should be connected via a serial port (9 way connector) | |||
The [http://www.rainsensors.com/| Hydreon Optical Rain Sensor] - Model RG-11 - uses an infrared sensor to detect rainfall with high precision. Some car windscreens have a similar sensor to automatically start wipers. Cumulus supports the RG11, via parameters in [[Cumulus.ini#Hydreon_specific:]] that are set using a RG11 screen within the configuration menu. | #*either to the Data Set Ready (pin 4) and Data Terminal Ready (pin 6), | ||
#*or to the Request To Send (pin 7) and Clear To Send (pin 8)]. | |||
#*You can connect two RG-11 sensors to the same port, one to DTS/DTR and one to RTS/CTS (one has to be in "It's raining" mode and one in "tipping bucket" mode). | |||
=Rain Gauge Location= | =Rain Gauge Location= | ||