5,838
edits
MX on Linux: Difference between revisions
m
→MX Distribution
m (→Installing MX) |
|||
| Line 203: | Line 203: | ||
First of all you need to configure FileZilla Client, unless you have done that previously and saved the configuration: | First of all you need to configure FileZilla Client, unless you have done that previously and saved the configuration: | ||
* Host - this is the IPv4 address of your Pi, I can't tell you what it is, but it is likely to be '''192.168.z.xy''' where the z is likely to be a single figure like 0 or 1, and the xy is two figures you can find out by looking for "pi" (or whatever host username you have set on your Pi) in the admin interface for your hub or router. (It can also be found out by typing <tt>hostname -I</tt>). Most networks are setup in a way that the subnet range is from 192.168.1.0 to 192.168.1.255. | * Host - this is the IPv4 address of your Pi, I can't tell you what it is, but it is likely to be '''192.168.z.xy''' where the z is likely to be a single figure like 0 or 1, and the xy is two figures you can find out by looking for "pi" (or whatever host username you have set on your Pi) in the admin interface for your hub or router. (It can also be found out by typing <tt>hostname -I</tt>). Most networks are setup in a way that the subnet range is from 192.168.1.0 to 192.168.1.255. | ||
* Username - the default for this is '''raspberrypi''' (although on older Pi it might be '''Pi'''), but you can may have changed this (as described earlier). (It can be found by typing <tt>hostname</tt>). | * Username - the default for this is '''raspberrypi''' (although on older Pi it might be '''Pi'''), but you can may have changed this (as described earlier). (It can be found by typing <tt>hostname</tt>) or by looking at the contents of the file '''/etc/hostname'''. | ||
* Password - again the default for this is '''raspberry''' but we changed it as one of the mandatory configurations earlier. | * Password - again the default for this is '''raspberry''' but we changed it as one of the mandatory configurations earlier. | ||
* Port - 22 is the default, and I have not said how you can change this! | * Port - 22 is the default, and I have not said how you can change this! | ||