5,838
edits
MX on Linux: Difference between revisions
From Cumulus Wiki
Jump to navigationJump to search
m
→Preparing for an install: typo correct
m (→Preparing for an install: mention "free -m") |
m (→Preparing for an install: typo correct) |
||
| Line 175: | Line 175: | ||
sudo apt autoremove | sudo apt autoremove | ||
</code> | </code> | ||
Each of those can be understood from information in previous section. | |||
Each of | |||
If you are installing onto a Pi zero, or similar slow computer, please ensure the size of the swapfile is as big as possible, as the mono-complete we will install is large. In linux, we type <code>free -m</code> to see our RAM size and our swapfile size. | If you are installing onto a Pi zero, or similar slow computer, please ensure the size of the swapfile is as big as possible, as the mono-complete we will install is large. In linux, we type <code>free -m</code> to see our RAM size and our swapfile size. | ||
To change swapfile size on the Raspberry Pi, you need to edit a file <code>sudo nano /etc/dphys-swapfile</code>. Move the cursor down line by line until it reaches '''CONF_SWAPSIZE=100'''. That is showing that the swapfile is only 99 mb | To change swapfile size on the Raspberry Pi, you need to edit a file <code>sudo nano /etc/dphys-swapfile</code>. Move the cursor down line by line until it reaches '''CONF_SWAPSIZE=100'''. That is showing that the swapfile is only 99 mb by default in the Raspberry Pi Operating System. Now move the cursor to the 100, and change it to "512" which is enough for mono even on a Pi zero. Next, stop, and restart the relevant service using <code>sudo /etc/init.d/dphys-swapfile stop && sudo /etc/init.d/dphys-swapfile start</code>. That should complete quickly, and we can type <code>free -m</code> again to see the 99 we saw previously has been replaced by 511. | ||
=== USB HID === | === USB HID === | ||
