5,838
edits
Cumulus.ini (Cumulus 1): Difference between revisions
m
→Read-Write parameters in the Station section: Minor restyling so ensure MX is consistent with this legacy
m (Restore lost section) |
m (→Read-Write parameters in the Station section: Minor restyling so ensure MX is consistent with this legacy) |
||
| Line 387: | Line 387: | ||
|- | |- | ||
|CalculatedDP=0 | |CalculatedDP=0 | ||
|Selected on same screen as other parameters. | |Selected on same screen as other parameters. Simple tick or not: | ||
* | * Tick (value shown as 1 in Cumulus.ini) then Cumulus will calculate wind chill from temperature and wind speed | ||
* | ** Note that there is a maximum temperature, and minimum wind speed, for Cumulus to make the calculation, see [[Wind_chill]] page | ||
* Don't tick (value shown as 0 in Cumulus.ini) action depends on '''Calibration settings''' | |||
** If Cumulus has non-default multiplier and/or offset settings for temperature or wind speed, Cumulus will calculate wind chill. This avoids the restriction in the Oregon Scientific stations where the dew point can never be below freezing point. | |||
** If station provides wind chill, then that will be used provided no multiplier/offsets have been specified for temperature or wind speed | |||
|- | |- | ||
|CalculatedWC=0 | |CalculatedWC=0 | ||
|Selected on same screen as other parameters. Available only from version 1.8.3 | |Selected on same screen as other parameters. Available only from version 1.8.3. Simple tick or not: | ||
* | * Tick (value shown as 1 in Cumulus.ini) then Cumulus will calculate wind chill from temperature and wind speed | ||
** Note that there is a maximum temperature, and minimum wind speed, for Cumulus to make the calculation, see [[Wind_chill]] page | |||
* Don't tick (value shown as 0 in Cumulus.ini) action depends on '''Calibration settings''' | |||
** If Cumulus has non-default multiplier and/or offset settings for temperature or wind speed, Cumulus will calculate wind chill | |||
** If station provides wind chill, then that will be used provided no multiplier/offsets have been specified for temperature or wind speed | |||
Note that some stations (Fine Offset, for example), do not make a wind chill value available to Cumulus. For these, Cumulus always calculates it. | Note that some stations (Fine Offset, for example), do not make a wind chill value available to Cumulus. For these, Cumulus always calculates it. | ||
|- | |- | ||
| Line 541: | Line 547: | ||
'''You should not select the previous parameter 'ConfirmClose' if you use this option.''' | '''You should not select the previous parameter 'ConfirmClose' if you use this option.''' | ||
|} | |} | ||
==== Spike Removal ==== | ==== Spike Removal ==== | ||