44
edits
Cumulus.ini: Difference between revisions
→Settings Configuration for MX
| Line 163: | Line 163: | ||
# At this stage, MX creates a very basic Cumulus.ini with the default settings (shown below). | # At this stage, MX creates a very basic Cumulus.ini with the default settings (shown below). | ||
#Open the [[MX Administrative Interface|admin interface]], and select the config wizard: [[File:dashboardwiz.jpg|800px|center]] | #Open the [[MX Administrative Interface|admin interface]], and select the config wizard: [[File:dashboardwiz.jpg|800px|center]] | ||
#The following screen will open | #The following screen will open [[File:wizard1.jpg|800px|center]] | ||
# At the very minimum, you must select a station type and units (as shown in image here) | # At the very minimum, you must select a station type and units (as shown in image here) | ||
# Optionally, move down the page, entering more settings, | # Optionally, move down the page, entering more settings, | ||
| Line 280: | Line 280: | ||
As a specific example, release 3.11.0 added emailing capability; that requires quite a lot of new parameters to be added to the file. You could use MX without these new parameters, but the Alarm Settings page would not allow you to click '''Enable''' until you had defined various settings on another Settings page, as well as on this Alarm Settings page. | As a specific example, release 3.11.0 added emailing capability; that requires quite a lot of new parameters to be added to the file. You could use MX without these new parameters, but the Alarm Settings page would not allow you to click '''Enable''' until you had defined various settings on another Settings page, as well as on this Alarm Settings page. | ||
=Tables listing Settings= | =Tables listing Settings= | ||